I have written the host software in Delphi, but there are also a lot of demos coded in C on Objective Development's webpage.The binaries and sources of the firmware and Delphi host software including a free LibUSB driver can be downloaded from here:Download Software

Avr Studio 4.13 Download

Download Zip: https://bltlly.com/2tLLta

HiI'm using AVR Studio 4.13 still and I was setting fuses for a brand new ATMega1284p chip.Should I turn off JTAG operation? ISP has been enabled. Brownout is set for 2.7 voltsHow large of a bootloader should I select? I selected 8.0Mhz - crystal with the longest startup delay.Will these setting work? Does anyone have a opinion on what I fuses I should select.This is my first time setting fuses to use an AVR for Arduino use.ThanksDon

Right, so I can take this simple \"island of holes\" board, wirewrap it up, bring in power via an FTDI module, bootload it via an AVR ISP MKii, then download a sketch via the FTDI module, and I'm the only one in the whole forum able to get this to work? 076b4e4f54